I have been looking at this site for over three years with WOW and buddy as my favorites.
I have read over 1000 posts and here is my take on the window install.
Starmark, Okna,Sunrise,Serious Windows would be the top of the line. Gorell and Simonton
a step below and I no Simonton could be bought by the homeowner from the Distributor.
I do not no if any of the other manufactures that the homeowner could bye
As far as the install of the window, if it is measured right 1/2 inch gap top and bottom and side to side not much to fill in with low expanding foam, caulk. check the outside for gaps and cap
This would be on a double hung window in my case a replacement of existing vinyl
window that has two screws holding it in on each side of the window.
In my experience I have seen contractors charge customers retail price of the window plus installation of 100 to 200 a window so on a typical install.
The contractor gets his install price plus the difference between his cost price and the retail price. I have also seen homeowners see the invoice the contractor gets from the manufacturer of the cost of the window.
Window install
- Windows on Washington
- Posts: 4868
- Joined: Wed Apr 04, 2007 11:21 pm
- Location: DC Metropolitan Area-Maryland/Virginia/DC
- Contact:
Re: Window install
Tom,
You don't need 1/2 cut back on all 4 sides. 1/8th inch cutback per side is just fine if the opening is relatively square.
You don't need 1/2 cut back on all 4 sides. 1/8th inch cutback per side is just fine if the opening is relatively square.
800-399-4623