Stucco install options

For those self-installers
Post Reply
Message
Author
scott1021
Posts: 1
Joined: Mon Jul 19, 2010 4:50 pm

Stucco install options

#1 Post by scott1021 » Mon Jul 19, 2010 5:21 pm

I have a frame house with fin aluminum windows. The stucco around the windows is 3/4" thick around the window perimeter and is flush with the face of the window. The stucco recesses into all four sides of the frame about a half inch. The interior is 1/2 sheet rock butting the window. The existing frame is two inches wide.
How do I measure for vinyl replacements?
How do I remove the old window?
What will finish the joint between the stucco and the new window?
Can anyone help please :D

windowman736
Posts: 25
Joined: Tue Jul 13, 2010 2:11 pm

Re: Stucco install options

#2 Post by windowman736 » Tue Jul 20, 2010 9:41 am

This is not a standard installation for a do it yourself job. Find a professional in your area that is familiar with aluminum removals in Stucco. You don't want to buy a high performance window and have an inadequate installation. I,m sure that there are homes in your area that have already been done. Perhaps you can get a referal from one of those.

TheWindowNerd
Posts: 1698
Joined: Sun Feb 22, 2009 5:52 pm
Location: SE PA & NJ; CT
Contact:

Re: Stucco install options

#3 Post by TheWindowNerd » Thu Jul 22, 2010 10:12 am

Take a diamond blade cut a kerf around the window, then take a saws all and cut through the nailing fin , pull out the old , install the new, finish to taste.

Post Reply