Mulling half moon window to single hung window

For all those Replacement Window questions
Post Reply
Message
Author
rchardwick
Posts: 1
Joined: Sun Mar 25, 2012 7:15 pm

Mulling half moon window to single hung window

#1 Post by rchardwick » Sun Mar 25, 2012 7:28 pm

I realize this is a forum for Vinyll Windows BUT does anybody have any ideals about mulling a Half moon to a single hung?? I have done side by side mulling but this is different and there are no instructions on the mfg website and the real window guy at Lowes won't be in till morning. The Store manager siad he could help me but when I threw him that curve ball he said well he had no experiance in that area go figure. I expexted as much that was why I was looking for the regula guy as he has been in that department for the last 10 years.

Any ideals or suggestions would be apriciated.


Thanks in advance randall

TheWindowNerd
Posts: 1675
Joined: Sun Feb 22, 2009 5:52 pm
Location: SE PA & NJ; CT
Contact:

Re: Mulling half moon window to single hung window

#2 Post by TheWindowNerd » Mon Mar 26, 2012 5:02 am

should post on DIY portion of board.

User avatar
Windows on Washington
Posts: 4396
Joined: Wed Apr 04, 2007 11:21 pm
Location: DC Metropolitan Area-Maryland/Virginia/DC
Contact:

Re: Mulling half moon window to single hung window

#3 Post by Windows on Washington » Mon Mar 26, 2012 8:33 am

What brand and type of window?

Mulling a half round to a single hung may be the exact same protocol as mulling two double hungs if they have the same type of accessory groove on the outside surface.

User avatar
HomeSealed
Posts: 2402
Joined: Tue Feb 16, 2010 6:14 pm
Location: Milwaukee, Madison areas
Contact:

Re: Mulling half moon window to single hung window

#4 Post by HomeSealed » Mon Mar 26, 2012 10:03 am

Windows on Washington wrote:What brand and type of window?

Mulling a half round to a single hung may be the exact same protocol as mulling two double hungs if they have the same type of accessory groove on the outside surface.
+1. Should be pretty simple depending on the type of window. Did you get a mull kit with it? Many of them come with instructions.

User avatar
Window4U (IL)
Posts: 1374
Joined: Fri Mar 11, 2005 3:58 pm
Location: Sales and Installation in Chicagoland and Central Illinois

Re: Mulling half moon window to single hung window

#5 Post by Window4U (IL) » Tue Mar 27, 2012 10:20 am

rchardwick wrote:I have done side by side mulling but this is different and there are no instructions on the mfg website and the real window guy at Lowes won't be in till morning.l

Wait until morning for the real window guy. There will be some sort of mull kit for them to furnish you.

Post Reply