Post subject: Aluminum frame is sticking out about 1/2" pass the stuc
Posted: Tue Oct 24, 2006 11:03 pm
Joined: Tue Oct 24, 2006 10:56 pm Posts: 3
Help...I am about to order and install a 118" XOX replacement window in my living room. The window will have a Z-Bar and today I noticed that the aluminum fram is sticking out pass the exterior stucco about 1/2". Should I use my Sawz-All and cut the protruding frame or should I get some stucco filler and even it out with the frame. I think if I install the replacement, the z-bar won't be flush with the stucco. Any suggestions?
John, use the sawzall to remove the protruding metal, and dont forget to apply a generous bead of sealant on the face of the old frame before installing the new window. You want to seal the back of the Z-Bar to the face of the aluminum.
Replaced the window this past weekend. Surprisingly it was very simple, just heavy. I did not have to cut the protruding frame because the Z Bar fit square with the frame. Luck or maybe it was designed that way. In any case the look is a huge improvement. Had lots of rain later and no leaks. Now I just have to figure out how to frame the gaps inside.
Users browsing this forum: No registered users and 1 guest
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum