For those self-installers
Post Reply
Posts: 2
Joined: Tue Jul 14, 2009 11:19 pm


#1 Post by scorpion » Wed Jul 15, 2009 7:23 pm

whats the easy way of doing flashing i have the bending tool and stuff is there any easy way of doing this tricks or some how to videos thanks

Posts: 100
Joined: Mon Mar 17, 2008 7:55 am
Location: scranton pa

Re: flashing

#2 Post by windowmike » Mon Jul 27, 2009 7:37 am

Flashing is to prevent water leakage and is best done with rubber flashing tape check out installationmasters, also jeld wen has good video on this. Brakeformed capping is what you are referring to. Start with sample pieces one foot long. Measure your existing exterior casing and make the sample to these dimensions. Your mistakes with samples lead to correct sizes. Good snips will make cutting easier and less frustrating. Cut and trial fit one end at a time. Good luck many guys avoid this work.

Post Reply